offset distance
英 [ˈɒfset ˈdɪstəns]
美 [ˈɔːfset ˈdɪstəns]
支（差）距；偏移
双语例句
- In the following example, two new CSS classes, fromAccount and amount, have been inserted to define a position offset of40 pixels, which is the approximate distance of two consecutive rows.
在下面的示例中，插入了两个新的CSS类fromAccount和amount，以定义40个像素的相对偏移，这是两个连续行的大致距离。 - We offset the better roads against the greater distance.
我们以较好的道路来弥补较远距离带来之不便。 - The better roads on the route are an offset for the greater distance. It is the most distant course that comes nearest to thyself.
这条线路的路面较好，对于路途之较远是一补偿。第十四篇章离你最近的地方，路程也最遥远。 - Inputting the offset distance: input it in the offset distance edit bar.
输入偏心距离：在偏心距编辑框中输入偏心距。 - We offset the greater distance by the better road.
我们走远点，也要走较好的路。 - The compatibility test of speed of linking to offset distance is done, followed by compatibility test of speed of link to roll rotation and correcting test.
首先做了拨禾链对偏距及车速的适应试验，然后又进行了校正实验及链速对摘辊转速的适应试验。 - Making recording trace to model trace smaller offset distance/ depth, with delay quantity is residual truncation error to correction which cross-correlation coefficient is most between the seismic trace and model trace.
利用偏移距与深度之比较小的记录道生成模型道，以求取的地震道与模型道之间互相关系数最大时的延迟量为剩余截断误差，进行校正。 - When the offset distance is bigger, the layer velocity derived with the straight line is no longer appropriate, but the layer velocity derived with the refraction line is still accurate.
但当偏移距较大时，直线法求得的层速度不再适用，而折线法求出的层速度仍然比较准确。 - The offset of the focal distance of this system could be defined properly by preliminary theory analysis, experimental demonstration and tracing the ray using illumination CAD soft-ware that programmed by ourselves.
通过理论分析、实验论证和用自编制的照明设计CAD软件进行光线追迹，较好地确定了该系统的焦移量。 - Since general velocity analysis often ignores the quartic item of equation, time difference should be corrected for the data of the far offset distance, and its velocity analysis error influences the stacking quality of data.
由于常规速度分析一般忽略计算公式中的四次项，因此，对于较大偏移距的资料就存在校正时差的问题，其速度分析误差影响了资料的叠加质量。 - When the offset distance is smaller on the wellhead, the layer velocity obtained with straight line and the refraction line is matched with that of actual formation velocity.
当井口偏移距较小时，直线法和折线法求取的层速度和地层真速度吻合； - The calculation of optimum offset distance in cam mechanism& the application of Microcomputer in the design of cam
凸轮机构最佳偏距的计算&微机在凸轮机构设计中的应用 - A Calculating Method for Determining Offset Distance and Minimum Basic Circle Radius of Cam Mechanism by Value
一种按[α]值同时确定凸轮机构偏距及最小基圆半径的计算方法 - At the same time, from the transverse direction comparison, discovered the offset distance and insufficiency, from comparison, put forward the physical measures to accelerate Jiangyou's economy development speed.
同时，对江油市的发展现状作了横向比较，从比较中找到差距和不足，根据比较，提出了加快发展的具体措施。 - Then a conclusion is gained that offsetting piston and increasing its offset distance can improve dynamic characteristic of internal combustion engine.
计算和仿真结果表明，活塞偏置布置和增大活塞偏置距离有利于改善内燃机的动态性能。 - This paper presents the VSP technology principle, data collection and interpretation in both zero and non-zero offset distance sides.
介绍了VSP（垂直地震剖面法）技术的基本原理、零偏和非零偏两个方面的数据采集与处理。 - Under the situation of having no precision requirements about ( advance-) to return-time ratio, slider stroke and offset distance etc., a useful method was provided in order to improve the effective force transmission performance of slider-crank mechanism.
在行程速比系数、滑块行程和偏距等没有精确要求的情况下，为提高曲柄滑块机构有效的力传动性能，提供了一种实用的方法。 - The offset distance from detector for guidance signal to maize straw and the steering track are measured.
测定了导向信号探测装置与玉米秸秆的偏距与前轮转向轨迹。 - Given the velocity ratio of S-to P-waves, the depth of reflector and the offset, the horizontal distance between source and the converting point can be determined by solving a quartic equation.
如果我们已知介质中横波与纵波速度的比值、水平界面的埋藏深度和炮检距，炮点到共转换点的水平距离就可以通过解一个四次方程求出。 - The algorithm is to disperse base surface to ( n+ 1) 2 point. According to the offset surface formula whose distance is d, n offset points can be got.
该方法为：将基曲面离散成（m+1）×（n+1）个数据点，根据距离为d的等距面的公式，计算得到（m+1）×（n+1）个等距点。 - Then, the corners on the boundary line are detected by the SUSAN approach and the control points between each two neighbor corners are determined by the offset distance. Last, the cubic B-Spline curve is used to fit the boundary.
算法首先通过边界跟踪获取图象边界，然后利用SUSAN原则提取边界线上的角点，接着根据偏移距离确定角点间的普通控制点，最后使用三次B样条曲线拟合边界。 - Curve fitting algorithm can be used to research the function relation between the wheel weight and the piston offset distance in the design of the wheel weight test system.
最佳拟合曲线法可寻找火车轮重测量仪设计中轮重与活塞位移间的函数关系。 - The rover station can fulfill JOB, stake-out and receive, calculation and logging, logging under LRK model, offset solution and logging, distance solution, coordination system definition, elevation calculation.
流动站具有JOB、放样与接收圈、计算和记录、LRK模式下的记录、偏移的解算和记录、计算距离、定义坐标系统和高程计算的功能。 - For CMP gather seismic data, in common midpoint-half offset distance, the prestack double square root operator could be used to continuate and strip layer by layer.
对于CMP道集地震数据，在共中心点-半偏移距中，可以利用波动方程的叠前双平方根算子，实现延拓，进行层层剥离。 - The points where the deviation happened could be found by the estimating error condition and the more real control apexes could be calculated according to the deviating points, the deviation direction and the offset distance, which aimed at automatically repairing the fitting curved surface.
通过误差判定条件找到偏差点，根据偏差点、偏差方向及偏差距离计算出曲面更真实的控制顶点；然后重置相应的控制顶点，达到自动修复拟合曲面的目的。 - The judge methods of offset rationality is deduced at element local coordinate, and ensure that the element plane distance between after offset and before is close to the offset distance.
推导了在单元局部坐标系下判断等距合理性的计算方法，并且保证了等距前后单元所在平面之间的距离尽可能地接近所要等距的距离。 - By controlling the offset distance EXF of the axis of outer cutter head to ensure the tooth thickness, avoiding the helical angle and curvature deviation generated by the existing algorithms.
通过控制外刀盘回转中心的偏距EXF保证了轮齿的齿厚，避免了现有算法产生的螺旋角偏差和曲率偏差。 - If planter is steered over this offset distance, it is frequent to occur with stubble impaction by the opener and implement blockage and planting quality degradation. But so narrow offset is too hard to ensure even by the most experienced driver under high concentration.
超出这个范围，则易发生开沟器碰到根茬、堵塞机具或严重影响播种质量。这样小的偏差，既使经验丰富的驾驶员在精力高度集中的情况下，也很难保证完全实现。 - We also study the combined effects of axial offset and gap distance.
也研究了轴偏移量和纳米管对间距的联合影响。 - This dissertation presents a definition of general offset curve, which has fixed offset distance, but variable offset direction. The offset direction is defined by the local coordinate system, which is formed of the tangent vector and the normal vector of every point on the curve.
本文利用曲线上各点的切向量和法向量所形成的局部坐标系来确定等距方向，从而给出一种广义偏距曲线的新定义。